UNITRACK: Turnout 15°R, 481mm
- Remove the silver cover plate of the turnout with the aid of a small screwdriver. Solder the two pins to the two points "C" and "D". In order to accommodate the cables of the decoder cleanly in the bedding body, remove a part of the plastic bars on the underside of the turnout: in the illustration Fig. 4-1black with "Cut off" marked. Also the metal cover must be released in the appropriate places from bars, it can otherwise short-circuits develop, which can damage the products.
- Solder the red cable of the decoder on the point "A" and the black cable of the decoder on the point "B".
- Solder the orange cable to the point "C" and the grey cable to the point "D". Please control here, if the fine wires of the magnet coil still firmly on the points "C" and "D" together with the wires of the decoder are soldered.
- Bore now at the point " E" a hole into the road bed (approx. 1 to 2mm) and you solder the yellow cable at the soldering lug. Fasten afterwards the soldering lug with aid of a small screw. Then they put the small screw into the pre-drilled hole. The ideal length ot the screw is 3mm. The screw head is on up side of the turnout. The screw head shouldn't affect other metal parts, for example rails.
- The screw of the Fig. 4-1 point "H" will displaced to the position "H" of the Fig. 4-2.
- Isolate the metal plate within the range of the plate with a piece electrical tape. Freeze now the plate again with the screws.
- At the end to freeze the decoder with the electrical tape on the underside of the turnout. You have to freeze also the possibility the decoder with one of the base plate screws. vgl. Fig. 5
Fig. 5 turnout left
